Idea On Do It Yourself Pipes

Many people attempt to do their own plumbing in order to save money on repair costs. They often fail due to a lack of proper plumbing knowledge or by using the wrong tools for the job. If you would like to do your own plumbing without doing more harm than good, then read the tips in the following article.

Avoid the bursting of pipes due to the change in the temperature. You need to allow the flow of heat to reach under the sinks and into the pipes, you have to keep the cabinet doors of the bathrooms and kitchens open. It is important to keep water running at both hot and cold faucets along with vanities that are in close proximity to exterior walls.

To deal with a frozen pipe, turn on the faucet closest to the pipe. This gives the water a place to exit as the pipe defrosts. This reduces pressure to keep the pipe from bursting, which could prevent a big mess in your home.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

If your pipes are prone to freezing, let the water trickle continuously in at least one faucet during weather that is below freezing. This will minimize the chances that the pipes will freeze and leave you without water. If water is continually running through the pipes and trickling out of a faucet, the pipes are less likely to freeze.

Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.

Do you have a frozen drainpipe? You can use a garden hose to thaw it out. First of all, remove the trap from the drainpipe and insert the hose until it will not go any further. While lifting up the other end of the hose, pour hot water down it. Keep pouring hot water down the hose until the drainpipe thaws. To save time with cleanup, keep a bucket underneath to catch the water that overflows.

Check your gas water heater periodically to make sure the pilot flame is lit. The correct color for this flame should be blue. The tip of the flame should be yellow. If you find that you are only seeing a yellow flame, you may need to call a professional for safety reasons.

If you have problems with a slow drain, there are easier things you can do other than removing the pipes to clean it. There are check over here made just for this purpose that you insert into the drain to loosen the clog so it washes away or grab it and remove it completely.

If you have an odor coming from one or more fixtures in your house, it is likely this has to do with the water in water traps. Each fixture has a water trap that is sealed off to prevent odors. If the water evaporates, the odors can surface. Therefore, try adding water to the traps.

Sometimes in the case of minor and or major emergencies we all have to become Mr. Fix it ourselves. If you've got blockage in your drains the first step is to try a commercial de-clogger like Drano. Simply pour it down the drain, wait ten minutes, and presto, your drain should be clear.

If you have an automatic sprinkler system, you want to consider getting a spring-loaded timer which can be attached directly to your hose. This prevents your lawn from getting too much water in case you forget to turn your system off. Getting too much water could kill your grass and plants.


When facing temperatures below freezing in the winter it is important to leave the hot water dripping. This makes sure that the pipes don't freeze over and saves you the expensive repair of fixing and or entirely replacing a broken pipe. Plumbing Edmonton Alberta of dripping hot water is well worth saving you from that large expense of replacing a broken pipe.

To make sure your sump pump will run in an emergency, routinely test it by adding several buckets of water into the sump pit. please click the next internet page should turn on, remove the water and turn off with ease. Do this regularly, especially if your sump pump doesn't run that often, to ensure it will work when needed most.

While you may not be able to tackle every problem that comes up, you can surely feel more confident about dealing with some of the basic stuff. Take any situation step by step, and you will find that it's not as difficult as you may have thought.

Leave a Reply

Your email address will not be published. Required fields are marked *